Toner Cartridge Drive Unit - Toshiba e-STUDIO556 Service Manual

4.8 Developer Unit
4.8.1

Toner cartridge drive unit

(1) Take off the right front inner cover.
( P.4-1 "4.1.2 Front right inner cover")
(2) Disconnect 1 connector.
(3) Loosen 1 screw to take off the bracket.
(4) Pull down the fixing pin and rotate it by 90º.
(5) Pull out the toner cartridge drive unit up to
approx. 30º, and then take it off in the
direction of the arrow.
4.8.2 Toner cartridge switch (SW2)
(1) Disconnect 2 connectors, remove 1 screw,
and then take off the toner cartridge switch
with the bracket.
(2) Remove 2 screws to take off the toner
cartridge switch.
© 2012 TOSHIBA TEC CORPORATION All rights reserved
Screw Bracket
Fig. 4-194
Toner cartridge drive unit
Fig. 4-195
Top cover
Screw
Toner cartridge detection switch
Fig. 4-196
4 - 69
Fixing pin
Screw
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4