Exit Cover Switch [Sw5] - Toshiba e-STUDIO556 Service Manual

4.11.5

Exit cover switch [SW5]

(1) Take off the left lower cover (= exit cover).
( P.4-4 "4.1.11 Left lower cover (Exit
cover)")
(2) Open the exit/reverse unit. Then disconnect
the connector and release the latch to take
off the exit cover switch.
4.11.6 Gate solenoid [SOL2]
(1) Take off the left lower cover (= exit cover).
( P.4-4 "4.1.11 Left lower cover (Exit
cover)")
(2) Open the exit/reverse unit. Then disconnect
1 connector, release the clamp and remove 3
screws to take off the gate solenoid.
Note:
The solenoid is normally screwed at the
position A shown in the figure at right.
However, the position of the solenoid can be
adjusted by moving this screw to the position
B when the flap valve of the solenoid is not
pulled enough.
© 2012 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-310
Gate solenoid
Fig. 4-311
Fig. 4-312
4 - 111
Exit cover switch
B A
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4