Drum Separation Finger - Toshiba e-STUDIO556 Service Manual

Note:
Do not touch the board parts (especially the
3 variable resistors shown in the figure) of
the image quality sensor.
4.7.7

Drum separation finger

(1) Take off the drum.
( P.4-61 "4.7.2 Drum thermistor (THM5)
and Drum")
(2) Take off the image quality sensor.
( P.4-64 "4.7.6 Image quality sensor
(S14)")
(3) Remove 2 screws to take off the plate on the
rear side.
(4) Remove the E-ring to take off the cam.
© 2012 TOSHIBA TEC CORPORATION All rights reserved
Variable resistor
Fig. 4-183
Screw
Fig. 4-184
E-ring
Fig. 4-185
4 - 65
Variable resistor
Screw
Plate
Cam
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4