How To Enable/Disable An Io Line; How To Enable/Disable Auxiliary Relay - Honeywell GENT Operating Instructions Manual

How to enable/disable an IO line

How to enable/disable an IO line
These operations are not applicable for a Network Node.
NA
An interface input/output line can be disabled or enabled. You will need to
know the IO line, device and loop numbers, these numbers can be found
in the site specifi c documents held by the person responsible for the fi re
system.
An output line of an interface unit may be assigned
to a sector and can only be disabled by disabling that
sector. This has the effect of also disabling all other
devices in the sector.
a. Press the MENU ON/OFF key.
b. Press the F1 button to select [Control].
c. Press the F4 button to select [UserCode]. At the fl ashing cursor using
the keypad input your PIN code and then press the Enter button.
d. To disable an IO line press the F2 button to select [Disable] or press
the F1 button to select [Enable], the display reads 'Enable' or 'Disable'.
e. Press the F2 button to select [IO Line]. At the fl ashing cursor using the
keypad input an IO line number.
f. Press the F2 button to select [Device]. At the fl ashing cursor using the
keypad input a device number from a range 1 to 200.
g. Press the F2 button to select [Loop]. At the fl ashing cursor using the
keypad input a loop number from a range 1 to 2.
h. Press the F2 button to select [Enter]. Notice the action has been
processed and a message appears on the display: 'IO line disabled/
enabled at Card n'. The disablement light will illuminate upon
disablement of an IO line.
28

How to enable/disable auxiliary relay

The control panel / network node has two
auxiliary relays that provides voltage free contacts
to control external equipment in the event of a fi re
or fault condition. The operation of the relays can
be disabled or enabled.
a. Press the MENU ON/OFF key.
b. Press the F1 button to select [Control].
c. Press the F4 button to select [UserCode].
At the fl ashing cursor using the keypad input
your PIN code and then press the Enter
button.
d. To disable the auxiliary relay press the F2
button to select [Disable] or press the F1
button to select [Enable]. This puts 'Disable'
or 'Enable' on the display.
e. Press the F4 button three times selecting
<etc> on each occasion and then press the
F2 button to select [Aux Rly]. At the fl ashing
cursor using the keypad input an auxiliary
relay number or range (1-2).
f. Press the F2 button to select [Enter].
Notice the action has been processed and a
message appears on the display: 'Aux Rly n
disabled/enabled'. The Disablement light will
illuminate upon disablement of an auxiliary
relay.