How To View A Zone Label; How To View A I/O Line Label - Honeywell GENT Operating Instructions Manual

How to view a zone label

How to view a zone label
This operation is not applicable for a
NA
Network Node.
A zone is a subdivision of a building used for
fi re detection. To view a zone label you will need
to know the zone number. You can fi nd this
information in the site specifi c documentation,
held by the person responsible for the fi re alarm
system.
a. Press the MENU ON/OFF button.
b. Press the F3 button to select [Info]. Ignore
step c. if an external printer is not fi tted or
is switched off.
c. To display a zone label press the F1 button to
select [Display] or to print a zone label press
the F2 button to select [Print]. Notice 'Display'
or 'Print' appears on the screen.
d. Press the F4 button to select <etc>.
e. Press the F2 button to select [Label]. Notice
'Label' appears on the display.
f. Press the F4 button once to select <etc>.
g. Press the F1 key to select [Zone]. Notice
'Zone' followed by a fl ashing cursor appears
on the display. Use the keypad to input a Zone
number from a range 1-128.
h. Press the F2 key to select [Enter]. Notice the
selected label information is either displayed
or printed.
30

How to view a I/O line label

This operation is not applicable for a Network Node.
NA
An interface unit can have up to four input/output (IO) lines. Each
line may have been given a label for display during an event. To view an
IO line label you will need to know the interface device address, the IO
line number and the loop number, which can found in the site specifi c
documentation held by the person responsible for the fi re alarm system.
a. Press the MENU ON/OFF button.
b. Press the F3 button to select [Info]. Ignore step c. if an external
printer is not fi tted or is switched off.
c. To display an I/O line label press the F1 button to select [Display] or
to print an I/O line label press the F2 button to select [Print]. Notice
'Display' or 'Print' appears on the screen.
d. Press the F4 button to select <etc>.
e. Press the F2 button to select [Label]. Notice 'Label' appears on the
display.
f. Press the F2 button to select [IO Line]. Notice 'IO Line' followed by
a fl ashing cursor appears on the display. Use the keypad to enter an
input/output line number from a range 1 to 4.
g. Press the F2 button to select [Device]. Notice 'Device' followed by
a fl ashing cursor on the display. Use the keypad to enter a Device
number (1-200).
h. Press the F2 button to select [Loop]. Notice 'Loop' followed by a
fl ashing cursor appears on the display. Use the keypad to input a loop
number (1 or 2).
i. Press the F2 button to select [Enter]. Notice the selected label
information is either displayed or printed.