Editing Labels; How To Edit A Device Label - Honeywell GENT Operating Instructions Manual

Editing labels

Editing labels
Any changes to labels
must be backed up
to the Memory, see
the section 'How to
save changes to the
memory'.
32

How to edit a device label

This operation is not applicable for a Network Node.
NA
There can be up to 200 devices connected to a loop, devices like fi re sensors
and manual call points. Each device can be given a label to identify its location in
the system. Devices in your system may have already been given labels and these
labels can be changed. To edit a device label you will need to know the device
number and the loop on which it resides. You can fi nd this information in the site
specifi c documentation, held by the person responsible for the fi re system.
a. Press the MENU ON/OFF button
b. Press the F2 button to select [Set Up].
c. Press the F4 button to select [UserCode]. A message is displayed: 'Enter access
code' followed by a fl ashing cursor. Use the keypad to input your PIN and then
press the Enter button.
d. Press the F4 button once to select <etc>.
e. Press the F1 button to select [Modify]. Notice 'Modify' appears on the display.
f. Press the F1 button to select [Label]. Notice 'Label' appears on the display.
g. Press the F3 button to select [Device]. Notice 'Device' followed by a fl ashing
cursor appears on the display.
h. Use the keypad to input a Device number.
i. Press the F2 button to select [Loop]. Notice 'Loop' followed by a fl ashing cursor
on the display. Use the keypad to input a loop number either 1 or 2.
j. Press the F2 button to select [Enter]. Notice the previous label appears on the
display with a fl ashing fi rst character to prompt the modifi cation, if there is no
label the line is blank.
k. Use the keypad to enter a label of up to 32 characters in length (28 for MCP) and
then press the Enter button.