Repair Function - Honeywell GENT Operating Instructions Manual

Maintenance

Repair function

This operation is not applicable for a Network Node.
NA
Any wiring fault on the system must be rectifi ed by an engineer from the servicing organisation, for contact details see the
log book. A wiring fault will require correction to the wiring before running a [Repair] command at the main panel.
The repair function is accessible using customer (level 2) password, however under normal circumstances it is unnecessary to
use this function.
a. Press the MENU ON/OFF key.
b. Press the F1 button to select [Test/Eng].
c. Press the F4 button to select [UserCode]. Notice a fl ashing cursor and a message on the display 'Enter access code'. Use
the keyboard to input your password and then press the Enter button.
d. Press the F1 button to select [Loop] and F1 button to select [Repair] notice 'Loop' followed by a fl ashing cursor on the
display. Use the keypad to input a loop number 1 or 2 and then press the F2 button to select [Enter].
38