Maintenance; Replacing The Glass On A Manual Call Point; Resetting The Resetable Element On A Manual Call Point - Honeywell GENT Operating Instructions Manual

And vigilon panel and network node fire detection

Hide thumbs Also See for GENT:

Table of Contents

Maintenance

a. Disengage the front cover from the call point assembly using

the end of the test key. Insert the key into the slots 'E' on the

underside of the call point to compress the retaining tabs and the

from the bottom edge lift out the cover.

b. Carefully remove broken glass from the call point.

Take appropriate precautions when clearing the

broken glass to prevent injury.

c. Insert the key in the keyhole and turn the key such that the tab is

at position 'F' and then insert a new glass as shown. Ensure the

glass has engaged into the yellow arm.

d. Hook the front cover onto the top edge of the call point assembly

and then push the bottom edge down until a click is heard and the

cover shuts onto the main assembly. Check both hooks on the top

of the front cover are locked onto the call point assembly.

e. Turn the test key anticlockwise one quarter of a turn such that the

glass is held under the yellow arm. The call point is now ready for

normal operation.

S4-34891

Spare MCP glass (Pack of 10)

Slide the keyhole cover upwards to expose the keyhole. Insert the

test key in the keyhole and turn it clockwise by one quarter of a turn.

Then turn the test key anticlockwise by one quarter of a turn to reset

the call point element.

YELLOW ARM

GLASS

Cover

Test Key

Table of Contents

Show Quick Links

Table of Contents