How To Enable/Disable A Zone; How To Manually Switch On / Off Fare - Honeywell GENT Operating Instructions Manual

How to enable/disable a zone

How to enable/disable a zone
These operations are not applicable for a Network Node.
NA
A zone is a subdivision of your premises that is protected
by the fi re alarm system. There can be up to 128 zones
confi gured in a system. Any zone operation can be disabled
or enabled. You will need to know the zone number, this can
be found in the site specifi c documentation held by the person
responsible for the fi re alarm system. From the panel:
a. Press the MENU ON/OFF key.
b. Press the F1 button to select [Control].
c. Press the F4 button to select [UserCode]. At the fl ashing
cursor using the keypad input your PIN code and then
press the Enter button.
d. To disable a zone: Press the F2 button to select [Disable]
or press the F1 button to select [Enable].
e. Press the F4 button to select <etc> and then press the F2
button to select [Zone]. At the fl ashing cursor using the
keypad input a zone number or range (1-128).
f. Press the F2 button to select [Enter]. Notice the action has
been processed and a message appears on the display
'Zone n enabled' or 'Zone n disabled'. The Disablement
light will be illuminated upon disablement of any zone.
26

How to manually switch On / Off FARE

The fi re alarm routing output via the FARE interface that
signals the Alarm Receiving Centre can be manually switched
On/Off. It may be necesssary to switch FARE to initiate fi re
fi ghting action. From the panel:
a. Press the MENU ON/OFF key.
b. Press the F1 button to select [Control].
c. Press the F4 button to select [UserCode]. At the fl ashing
cursor using the keypad input your PIN code and then
press the Enter button.
d. Momentarily press the F4 button to select <etc> until
[FARE] option is displayed.
e. Press the F4 button to select [FARE].
f. To switch On or Off signal to Fire Alarm Routing Equipment:
Press the F1 or F2 button to select [Off] or [On].
g. Press the F2 button to select [Enter]. Notice the action has
been processed and a message appears on the display
'FARE activated' or 'FARE deactivated'.