Honeywell GSMV4G Installation And Setup Manual page 43

Operating with 2G service
[E]
PriRSSI 2G
-xxxdbm stat
RAT Ec/N0
2G NA
Cntry Netw LAC
xxx xxx
Cell BaseSt Chan
xxxx xxxx
Second Site
Available
Status Display Screen 1
REG
PriRSSI – Primary site level in dBm.
x
2G – Communicator is on the2G network where "stat"
can be:
Good
OK
Marginal RSSI –99 to –104 dBm
Bad
REG – Registration status where "x" can be:
N – Not Registered
H – Registered Home
S – Searching
D – Registration Denied
R – Registered Roaming
? – Unknown Registration State
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the last screen.
Status Display Screen 2
RAT – Radio Access Technology.
Ec/N0 – Carrier Noise Ratio (CNR). This is not a 2G
parameter, therefore, NA is displayed.
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Status Display Screen 3
Cntry – Country Code
xxxxx
Netw – Network Code
LAC – Local area code
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Status Display Screen 4
Cell – Base Station ID
xxx
BaseSt – Base Station Antenna Sector
Chan – Control Channel in use
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the previous field.
Status Display Screen 5
RSSI
Secondary Site RSSI availability. Available or Not
Available will be displayed.
Press the [space] key to go to Status Display Screen 1.
Press the [backspace] key to go to the previous field.
Section 5: Programmer Keyboard Commands
RSSI –20 to –89 dBm
RSSI –90 to –98 dBm
RSSI –105 to –150 dBm
5-3