Exiting Programming Mode; Setting Factory Defaults - Honeywell GSMV4G Installation And Setup Manual

GSMV4G/GSMVCN4G Installation and Setup Guide

Exiting Programming Mode

To exit the programming mode, press [N] in response to the "REVIEW?" question. Then
press [Y] to the "Exit Prog Mode?" question. Upon exiting, the message "Checking Root File
TX Path" will be displayed, and the configuration file at the server is updated to log the
changes made. When complete, the message "DONE" is displayed to indicate the file was
successfully uploaded.
If critical configuration changes were made, such as the mode of operation, the communicator
will reset to ensure that the programming features are enabled.
If the file is not successfully uploaded, one of the following prompts will be displayed. Follow
the steps shown below until the upload is successful.
Display
Cannot Upload
Try Again? Y/N_
Failed to Update
Root File!

Setting Factory Defaults

To reset the programming options to factory-default values, press [ESC] at the "Exit Prog
Mode?" prompt.
Set Default?
Y/N_
If you press [Y], all programmed values are reset to the original factory settings. PLEASE
NOTE THAT THIS WILL ERASE ANY PASSWORD THAT MAY HAVE BEEN ENTERED.
After pressing [Y], the Create Password prompt appears (see Prompt 4).
3-18
Description
GSM communicator is not yet
initialized.
Network problem, or you
answered "N" to "Cannot Upload
Try Again?" prompt.
Press [Y] to reset factory default values.
Press [N] to cancel this function.
What to do
Wait for RSSI LEDs to be lit.
Press [Y].
Initiate the Force Server Update
command by pressing the [0] key; refer
to Section 5: Programmer Keyboard
Commands.