Chapter 1 - Vehicle Mounting And Accessory Installation; Introduction; Prepare For Vehicle Mounting; Quick Start - Honeywell Thor VM3 User Manual

1
Vehicle Mounting and Accessory Installation

Introduction

The Thor VM3 is designed to be mounted to a Quick Mount Smart Dock in a vehicle with either a RAM mount system. A power
cable is provided with the Thor VM3 dock. Optional communication cables are available.
Vehicle mounting brackets are specifically designed for vehicle mount applications. The vehicle mounted assembly restrains the
Thor VM3 and isolates it from shock and vibration. A RAM metal table stand is available to secure the Thor VM3 and dock when
in an office environment, for example.
The vehicle mount holds the Quick Mount Smart Dock and the Thor VM3 attaches to the dock. The dock remains attached to
the vehicle, however, the Thor VM3 has a quick release located on the lower rear side that allows the Thor VM3 to easily be
removed from the dock. The Thor VM3 can be operated for a minimum of 30 minutes from an internal UPS battery when not
attached to a dock. The Thor VM3 can be transferred from one dock equipped vehicle to another for easy portability. The dock
provides accessory attachment and conditioned power for the Thor VM3.
Overhead, dash and roof support pillar mounting is via a RAM Mount accessory which includes all the hardware required for
vehicle mounting.
Never put the Thor VM3 into the vehicle mounted assembly until the assembly is securely fastened to the vehicle.

Prepare for Vehicle Mounting

The Thor VM3 should be secured to an area in the vehicle where it:
• Does not obstruct the driver's vision or safe vehicle operation.
• Will be protected from rain or inclement weather.
• Will be protected from extremely high concentrations of dust or wind-blown debris.
• Can be easily accessed by a user seated in the driver's seat while the vehicle is not in operation.

Quick Start

The following list outlines, in a general way, the process to follow when mounting the Thor VM3 in a vehicle. Refer to the fol-
lowing sections in this document for more details.
1. Install RAM Mount
2. Place Thor VM3 in the Dock
3. Adjust the Thor VM3 to the best viewing angle.
4. Install Remote Antenna
5. Connect Cables
6. Connect vehicle power:
• 12-48 VDC Vehicles (10-60 VDC Direct Connection)
• 60-144 VDC Vehicles (50-150 VDC Power Supply, Screws on Top of Lid)
• 60-144 VDC Vehicles (50-150 VDC Power Supply, Screws on Side of Lid)
• Thor VX8 / Thor VX9 Adapter Cable
• VX6 / VX7 Adapter Cable
7. Secure all cables in
The Thor VM3 is ready for use.

Maintenance - Vehicle Mounted Devices

Check the vehicle mounting hardware frequently and re-tighten if necessary.
If the vehicle mounting hardware and connections become broken, loose or cracked, the assembly must be taken out of service
and replaced. Contact Technical Assistance
(page 1-18) to the vehicle.
(page 1-16).
(page 1-45) if necessary.
(page 1-23) for any peripherals.
(page 1-37)
(page 1-36)
Strain Relief Cable Clamps
(page 6-1) for help.
(page 1-25)
(page 1-23).
(page 1-33)
(page 1-29).
1 - 15