Parameter 31: Operator Log On - Honeywell FBII CP-220A Hookup And Installation Instructions

REMEMBER!
To leave the
Programming Mode at
any time, press the
Esc
key. Doing so will
return the CP-220A to
its normal operating
mode. Programming
changes will be stored
automatically.
PARAMETER 31:
Operator
Log On
01/13/95 08:00:15
01/13/95 17:00:45
Page 2-32 Section 2: Programming the CP-220A CP-220A Central Station Receiver
Advancing to Next Parameter:
The next parameter in Category A is PARAMETER 31. Because it is not
sequential, it cannot be reached with a single press of the
to PARAMETER 31, press the N key.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 27]) with its first digit flashing, indicating its request for the
desired parameter number. Press either:
• 3 then 1 , or
• the
NOTE: When the
immediately – not its number.
CHANNEL DAVE 1235 MM/DD/YY HH:MM:SS
Background:
For purposes of Central Station security, the CP-220A has been designed to
provide an accurate accounting of the individuals who use it – with the
capability of tracking up to 19 operators at the Central Station. If this
function is desired, a 4-digit numeric I.D. code and (up to) 4 characters
identifying each such operator must be specified for each such operator in
this parameter.
At the beginning of his/her shift, an operator must "log on" by entering
his/her 4-digit I.D. code at the receiver's keyboard, which causes both the
receiver to display (for example) [JANE LOG ON] and an attached printer to
print:
JANE LOG ON
When the operator's shift ends, he/she is required to enter the same 4-digit
code, which will similarly cause the receiver to display (for example) [JANE
LOG OFF] and an attached printer to print:
JANE LOG OFF
At this time, the next operator can log on with his/her respective code.
Programming Procedures:
When PARAMETER 31 is initially selected, the CP-220A will display
information about the first operator, "Operator 01." The following procedure
should be used to program (or modify what has already been programmed)
as many of the 19 available operators as desired:
key
is used, the name of the next parameter appears
Hook-Up and Installation Manual
key. To advance