Parameter 14: T-Header - Honeywell FBII CP-220A Hookup And Installation Instructions

REMEMBER!
To leave the Programming
Mode at any time, press the
Esc key. Doing so will
return the CP-220A to its
normal operating mode.
Programming changes will
be stored automatically.
PARAMETER 14:
T-Header
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 13]) with its first digit flashing, indicating its request for the
next parameter number. Press either:
• 1 then 4 , or
• then
• the
NOTE: When the
immediately – not its number.
T-HEADER 00
Background:
PARAMETER 14 specifies the ASCII character known as the T-Header
(i.e., Time-Header), which is sent from the CP-220A to the Automation
System, indicating that the Date and Time information supplied by the
CP-220A (see PARAMETER 13 on the previous page) will immediately
follow. As such, the ASCII code producing the desired character is a
two-digit value that should be dictated by the Automation System's
computer.
NOTE: See PARAMETER 11 (on page 2-79) for information on ASCII
coding and the ASCII Character Set.
In keeping with the approach used in the CP-220A's factory programming –
in which the use of an Automation System is not assumed – [00], the default
for PARAMETER 14, disables the T-Header, and prevents it from being
sent.
NOTE: To properly use PARAMETER 13, PARAMETER 14 must be
programmed with a value between [01] and [FF].
Programming Procedures:
When entering PARAMETER 14, [T-HEADER 00] is displayed, with the
first [0] flashing. Any ASCII value between [01] and [FF] may be
programmed by using the NEXT key or the MANUAL/PREVIOUS key to
change the first character, as required. Once this is done, use the
to move to the second character. As before, use either the NEXT key or
the MANUAL/PREVIOUS key to change it, if necessary. Subsequent
movement between the two digits can be accomplished through the use of
the key or the
CP-220A Central Station Receiver
Hook-Up and Installation Manual
key and 4 , or
key
is used, the name of the next parameter appears
MM/DD/YY HH:MM:SS
key
.
Section 2: Programming the CP-220A Page 2-87
key