Parameter 03: Receiver Number - Honeywell FBII CP-220A Hookup And Installation Instructions

PARAMETER 03:
Receiver Number
REMEMBER!
To leave the
Programming Mode
at any time, press
the Esc key. Doing
so will return the
CP-220A to its
normal operating
mode. Programming
changes will be
stored automatically.
Page 2-8 Section 2: Programming the CP-220A CP-220A Central Station Receiver
From the previous display, press 0 and 3 . The following screen appears:
RECEIVER NUMBER 0 MM/DD/YY HH:MM:SS
Background:
A Receiver Number must be assigned to each CP-220A. The Receiver Number
allows Central Stations to identify, track, and route incoming data in the
event that more than one Receiver is being used. In Central Stations
employing several Digital Receivers and a computerized Automation
System, the Receiver Number becomes essential to this process. In either
case, the Receiver Number becomes part of the alarm (or trouble) report.
Programming Procedures:
36 different Receiver Numbers (or designations) are available for each
CP-220A. Any number between 0 (zero) and 9 and any letter between A and
Z may be entered as required.
Press the NEXT key or the MANUAL/PREVIOUS key until the desired
choice is reached.
Default:
The factory has pre-programmed each CP-220A as Receiver 0 (zero). Unless
there are other considerations like those already mentioned, this designation
should be satisfactory at this time.
Advancing to Next Parameter:
After programming PARAMETER 03, press the N key to advance to
PARAMETER 04 – the next parameter in Category A.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 03]) with its first digit flashing, indicating its request for the next
parameter number.
You can reach PARAMETER 04 in one of several ways. Press either:
• 0 then 4, or
• the
• the
NOTE: When the
immediately – not its number.
key and 4 , or
key
is used, the name of the next parameter appears
Hook-Up and Installation Manual