REMEMBER!
To leave the
Programming Mode at
any time, press the
Esc
key. Doing so will
return the CP-220A to
its normal operating
mode. Programming
changes will be stored
automatically.
PARAMETER 30:
Slot English
On/Off
Page 2-28 Section 2: Programming the CP-220A CP-220A Central Station Receiver
2.
Depress the
will flash.
3.
Depress the number of the "destination" slot to which the slot selected
in step 1 must be copied; the display will now read [COPY SLOT 1 TO
SLOT X] (where "X" is the "destination" slot)
4.
Depress the N key to effect the copying; PARAMETER 29 will again be
displayed; to perform multiple copies from one slot to several slots, see
below; otherwise skip to "Advancing to Next Parameter", which follows.
Copying from One Slot to Multiple Slots
5.
Make the first copy as described in the previous steps. Press N to
return to the [COPY SLOT 1 TO SLOT 1] display.
6.
If necessary, use the keypad to enter the number of the "source" slot (if
not Slot 1).
7.
As before, depress the
8.
Depress the N key to effect the copying
9.
Repeat Steps 5 through 8, as required, until the copying process is
complete; use either the
SLOT] and the [TO SLOT] fields.
Advancing to Next Parameter:
After programming PARAMETER 29, press the N key to advance to
PARAMETER 30 – the next parameter in Category A.
displays the parameter just programmed ([PARAMETER NUMBER 29])
with its first digit flashing, indicating its request for the next parameter
number.
You can reach PARAMETER 30 in one of several ways. Press either:
• 3 then 0 , or
• the
NOTE: When the
immediately – not its number.
SLOT ONE ENGLISH ON MM/DD/YY HH:MM:SS
Background:
In PARAMETER 28, descriptive words could be produced and used in the
reporting of events for any Report Code (between 0 and 9) received by any of
the CP-220A's active Line Cards (slots). In PARAMETER 29, copying such
wording to any other Line Card was possible if you wanted to use the same
descriptive language for Codes 0-9.
key to move past the [TO SLOT] field; the seconde [1]
key to enter the "destination" slot.
or the
key
is used, the name of the next parameter appears
Hook-Up and Installation Manual
keys to move between the [COPY
The CP-220A