Honeywell AreaRAE Plus User Manual page 80

AreaRAE Plus & AreaRAE Pro User's Guide
6. Now lift the sensor electrode panel from the module:
7. Clean the sensor electrode panel in a solution of isopropanol lamp cleaner (included, along with
cleaning swabs, in a PID Lamp Cleaning Kit, part number 500-0014-010, package of 10), and
allow it to dry.
8. Clean the lamp's window with a cleaning swab dipped in isopropanol lamp cleaner, and allow it
to dry. Do not touch the lamp window with your fingers, as the residual oils will shorten its life.
9. Inspect the electrical contacts. Clean them with a swab dipped in lamp cleaner if they appear to
need cleaning (make sure the contacts are not pressed down when you are done):
10. Reassemble the sensor module by placing the sensor electrode panel back in place and firmly
pressing the cap back onto the top.
11. Place the sensor module back into the AreaRAE Plus/Pro. Make sure the index points are aligned
(it can only go in one way).
12. Carefully place the cap back onto the AreaRAE Plus/Pro and tighten the screw.
Match index
points on sensor
module with
sensor slot
80