Wifi - Honeywell AreaRAE Plus User Manual

AreaRAE Plus & AreaRAE Pro User's Guide
Unit ID
Each instrument in an ISM network must be assigned a unique Unit ID (between 00 and 99).
Make sure that the unit ID is not duplicated among any of the units within the same network.
1. Press [Y/+] to increase the number and [N/-] to advance to the next digit.
2. After moving to the last digit and making changes, press [MODE].

Press [Y/+] to save the change.

Press [N/-] to undo the change.

12.3.7 WiFi

You can turn the WiFi radio's power on or off.
1. Press [Y/+] to see on and off states, and which is selected.
2. Press [N/-] to scroll to "On" or "Off."
3. Press [Y/+] to select.
4. Press [Y/+] to "Save." You can also press [N/-] to undo.
In order to communicate via WiFi, you must configure WiFi settings for the AreaRAE Plus/Pro to match
your router by using ProRAE Studio II:
1. Connect a USB cable between the AreaRAE Plus/Pro and a PC running ProRAE Guardian.
2. In Normal mode, press the [N/-] key until the screen shows "Enter Communication Mode?"
3. Press [Y/+].
4. Start ProRAE Studio II on the PC.
5. Log in as Administrator. You must provide a password (the default is "rae".)
6. Click the "A" (for Automatic) detection.
7. When the AreaRAE Plus/Pro shows up in the list, click on it and then click "Select."
8. Click "Setup" when the list of items is shown on the left. This downloads the instrument's setup.
9. Click "WiFi." This is where you see the current WiFi parameters and can set new ones.
50