Programming; Enter Programming In Basic Mode - Honeywell AreaRAE Plus User Manual

AreaRAE Plus & AreaRAE Pro User's Guide

12 Programming

The menu in Programming Mode is to adjust settings, and calibrate sensors. It has the following
submenus:

Measurement

Alarms

Datalog

Wireless

Monitor

Calibration

12.1 Enter Programming In Basic Mode

Programming in Basic Mode is limited to calibration only. A password is required to access other
programming menus.
1. To enter Programming Mode, press and hold [MODE] and [N/-] until you see the Password screen.
2. Input the 4-digit password:
 Increase the number from 0 through 9 by pressing [Y/+].
 Step from digit to digit using [N/-].
 Press [MODE] when you are done.
If you make a mistake, you can cycle through the digits by pressing [N/-] and then using [Y/+] to change
the number in each position.
Note: The default password is 0000.
Note: The password screen appears when you enter the Programming Mode the first time after turning the
instrument on in Basic Mode, and each time after that.
36