Connecting The Speakertrack 60 Camera - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80
Contents
Connecting the SpeakerTrack 60
camera
Cisco TelePresence SpeakerTrack 60 uses two cameras
working together with a built-in microphone array. The system
can track and show the person speaking automatically.
Connecting the camera
Connect the camera to the codec as illustrated to the right.
Refer to the installation guide that comes with SpeakerTrack
60 for information about camera assembly and cabling.
Configuration
Use the Cameras SpeakerTrack Mode setting to enable
(Auto) or disable (Off) the speaker tracking functionality.
If set to Off speaker tracking cannot be used; if set to Auto
you can use the user interface (Touch 10) to switch the
speaker tracking on or off at any time.
Tracking mode
If you want the tracking algorithm to react faster to detected
changes, you should change the Cameras SpeakerTrack
TrackingMode from Default to Fast.
Then the camera view will change to a new speaker faster.
This can also be done from the Administrator Settings menu
on the Touch controller. Tap Tracking, and set
to NORMAL or FAST.
D15105.05 SX80 Administrator Guide TC7.3, OCTOBER 2015.
Introduction Web interface
Use either Ethernet port 2 or 3.
Tracking Mode
You may have more than two devices that must be connected to either Ethernet port 2 or 3 on the codec. If so, insert a network switch between
*
these devices and Ethernet port 2 or 3.
System settings
*
Power
adapter
Power
(100-240 VAC, 50/60 Hz)
Always use the provided power cable and
adapter (12 V , minimum 6.5 A).
DC
132
Administrator Guide
Setting passwords
Use camera inputs 1 and 2 for HDMI.
The camera surface may
be hot when the camera
is in operation.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Appendices Appendices