Cisco TelePresence SX80 Administrator's Manual page 138

Cisco TelePresence SX80
Contents
Briefing room set-up
(page 3 of 3)
Configure the codec
1. Open a web browser and enter the IP address of the
video system in the address bar.
To find the IP address (IPv4 or IPv6), open the
menu on Touch 10 and tap System
2. Go to Configuration > Room Types.
3. Click the Briefing thumbnail to push the corresponding
configuration to the codec.
Note that the cameras and displays must be connected
as described in Connecting cables
The Settings menu can be accessed from the drop down window
*
that appears when you tap the contact information in the upper, left
corner of the Touch 10 user interface.
D15105.05 SX80 Administrator Guide TC7.3, OCTOBER 2015.
Introduction Web interface
Change room mode while in a conference
These are the pre-defined modes for the Briefing room:
• Local Presenter (the presenter is in the room)
• Remote Presenter (the presenter is calling in)
Settings
*
Information.
• Discussions (for discussions between different sites with
local presenter in the room)
Switching from one mode to another implies changing the
camera input sources and changing the remote and local
screen layouts.
on page 137.
Switch to another room mode
While in a conference, you can switch to another mode using
the Touch 10 user interface.
1. Tap Layout
2. Tap the thumbnail that represents the mode you want to
change to.
Switching room modes automatically
The following situations cause an automatic mode change:
• When you start to share a presentation locally, the system
will automatically change to the Local Presenter mode.
• When the far end starts to share a presentation, the
system will automatically change to the Remote Presenter
mode.
Note the following exception: The room mode will not change
automatically if the current mode is Discussions.
System settings
on Touch 10.
Room mode thumbnails
138
Administrator Guide
Setting passwords
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Appendices Appendices