Power Switch, Shutdown Button And Led Indicators - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80
Contents

Power switch, shutdown button and LED indicators

Shutdown button
The shutdown button on the front panel can be
used to switch the codec on/off, provided the
power switch on the codec's rear side is on.
• To switch off the codec, hold the button
until the LEDs go out.
• To switch on the codec, hold the button
until the LEDs flash. It may take a few
minutes for the codec to start up. The
system is ready for use when the Power
LED lights steadily.
The shutdown button can also be used to
factory reset the codec, refer to the ► Factory
resetting the codec appendix.
D15105.05 SX80 Administrator Guide TC7.3, OCTOBER 2015.
Introduction Web interface
Front panel LEDs
Power:
Blinks when the system is starting up.
Steady light when the codec is ready for use.
Pulsates when the codec is in standby.
In Call:
Steady light when in call.
IR:
Not in use.
Alarm:
Lights steady when a serious error occurs.
System settings
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
128
Administrator Guide
Setting passwords Appendices Appendices
Power switch
The power button on the codec's rear side is
the main on/off switch for the codec.
It may take a few minutes for the codec to
start up. The system is ready for use when the
Power LED lights steadily.
Note that you can use the shutdown button on
the front panel to switch the codec on/off, as
long as the power switch is in on position.