HP A7500 Series Command Reference Manual page 41

Examples
# Send message hello abc to the AUX user interface 0.
<Sysname> send aux 0
Enter message, end with CTRL+Z or Enter; abort with CTRL+C:
hello abc^Z
Send message? [Y/N]:y
<Sysname>
***
***
***Message from aux0 to aux0
***
hello abc
<Sysname>
# Assume you are using VTY 0. Before you restart the device, to inform users that are accessing the
device through other user interfaces, perform the following steps.
Display information about all users
•
<Sysname> display users
The user application information of the user interface(s):
Idx UI
+ 18 VTY 0
19 VTY 1
Following are more details.
VTY 0 :
Location: 192.168.1.26
VTY 1 :
Location: 192.168.1.20
+ : Current operation user.
F : Current operation user work in async mode.
// The output shows that a user is using VTY 0.
<Sysname> send vty 1
Enter message, end with CTRL+Z or Enter; abort with CTRL+C:
Note please, I will reboot the system in 3 minutes!^Z
Send message? [Y/N]:y
// A message is sent to VTY 1, telling that the system will reboot in 3 minutes.
If a user is trying to log in through VTY 1, the message appears. (VTY 1 receives the message from
•
VTY 0 when the interface GigabitEthernet command is input.)
[Sysname] interface gigabiteth
***
***
***Message from vty0 to vty1
***
Delay Type Userlevel
00:00:00 TEL 3
00:00:03 TEL 3
34