Parity - HP A7500 Series Command Reference Manual

Description
Use the modem timer answer command to set the maximum amount of time that the modem waits for the
carrier signal after the off-hook action during incoming call connection setup.
Use the undo modem timer answer command to restore the default.
Examples
# Set the maximum amount of time that the switch-side modem waits for the carrier signal after the
off-hook action to 45 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] modem timer answer 45

parity

Syntax
parity { even | mark | none | odd | space }
undo parity
View
User interface view
Default level
2: System level
Parameters
even: Performs an even parity check.
mark: Performs a mark parity check.
none: Performs no parity check.
odd: Performs an odd parity check.
space: Performs a space parity check.
Description
Use the parity command to set a parity check method.
Use the undo parity command to restore the default.
By default, no parity check is performed.
NOTE:
• The command is only applicable to the asynchronous serial port (console port).
The parity check setting must be the same for the user interfaces of the connecting ports on the device
•
and the target terminal device for communication.
Examples
# Configure the Console port to perform odd parity check.
<Sysname> system-view
[Sysname] user-interface aux 0
31