Attaching The Access Point To The Mounting Plate - Cisco Aironet 1130AG Series Hardware Installation Manual

Attaching the Access Point to the Mounting Plate

Attaching the Access Point to the Mounting Plate

Follow these steps to attach the access point to the mounting plate:
Open the access point cover (see the
Step 1
In the cable bay area, pull the cables through one of the access point cable openings (see
Step 2
In the cable bay area, line up the visible access point keyhole with the mounting plate keyhole clip
Step 3
located near the security padlock hole (see
Figure 2-12 Aligning the Keyhole Clip to the Access Point Keyhole
1
2
3
Insert the keyhole clip into the keyhole and maintain a slight pressure to hold the access point in place.
Step 4
Slightly rotate the access point from side-to-side until you hear the second keyhole clip falling into the
Step 5
other keyhole (not visible).
Slide the access point back over the keyhole clips. You will hear a click when the locking detent contacts
Step 6
the access point and locks it into place.
For instructions on connecting your cables, refer to the
section on page
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
2-16
C I S C O C O N F I D E N T I A L -
Access point keyhole
Mounting plate keyhole clip
Mounting plate
2-17.
D r a f t 2
"Opening the Access Point Cover" section on page
Figure 2-12).
4 Security screw hole
5 Padlock hole
"Connecting the Ethernet and Power Cables"
Chapter 2 Installing the Access Point
2-8).
Figure
OL-6226-01
2-6).