Cisco Aironet 1130AG Series Hardware Installation Manual page 38

Mounting the Access Point
Place the T-rail clip over the T-rail and close the T-rail clip (see
Step 4
Tighten the two T-rail locking set screws to prevent the T-rail clip from moving.
Step 5
Observe the T-rail width detent letter (A, B, or C) that corresponds to the T-rail width.
Step 6
Align the corresponding (A, B, or C) holes on the mounting plate over the T-rail mounting plate holes.
Step 7
Hold the mounting plate and insert a 6x32x1/4 flat head screw into each of the corresponding (A, B, or
Step 8
C) holes and tighten.
If needed, drill or cut a cable access hole (see
Step 9
pull the cables through the access hole until you have about 1 foot of exposed cables protruding from the
hole.
To attach the access point to the mounting plate, see
section on page
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
2-12
C I S C O C O N F I D E N T I A L -
2-16.
Chapter 2
D r a f t 2
Figure 2-4).
Figure 2-7) large enough for the access point cables and
"Attaching the Access Point to the Mounting Plate"
Installing the Access Point
OL-6226-01