Checking Basic Settings; Ssid - Cisco Aironet 1130AG Series Hardware Installation Manual

Checking Basic Settings

Message type
Boot loader errors
Cisco IOS errors
Checking Basic Settings
Mismatched basic settings are the most common causes of lost connectivity with wireless clients. If the
access point does not communicate with client devices, check the following areas.

SSID

Wireless clients attempting to associate with the access point must use the same SSID as the access point.
If a client device's SSID does not match the SSID of an access point in radio range, the client device will
not associate. The access point default SSID is tsunami.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
6-4
C I S C O C O N F I D E N T I A L -
Cable Bay Area
Ethernet LED Radio LED
Red Red
Off Red
Off Amber
Amber Off
Red Off
Amber Amber
Red Amber
Amber Amber
Blinking n/a
amber
n/a Blinking
amber
Red Red
n/a n/a
Blinking Blinking
green green
D r a f t 2
Top of Unit
Status LED Meaning
Red DRAM memory test failure.
Blinking red Flash file system failure.
and blue
Blinking red Environment variable (ENVAR)
and light
blue
Blinking red Bad MAC address.
and yellow
Blinking red Ethernet failure during image recovery.
and off
Blinking red Boot environment error.
and off
Blinking red No Cisco IOS image file.
and off
Blinking red Boot failure.
and off
n/a Transmit or receive Ethernet errors.
n/a Maximum retries or buffer full occurred on the radio.
Orange Software failure; try disconnecting and reconnecting
unit power.
Orange General warning, insufficient inline power.
Blinking User activation of location indicator.
green
Chapter 6 Troubleshooting
failure.
OL-6226-01