Chapter 2
Installing the Access Point
To attach the access point to the mounting plate, see
section on page
Mounting on a Desktop or Shelf
When placing the access point on a desktop of shelf, you do not need the mounting plate. The access
point has four rubber pads on the bottom to help prevent sliding or scratching the surface of your desktop
or shelf. For information on connecting the access point cables, see the
Power Cables" section on page
Rotating the Cisco Logo
The Cisco logo on the top of the unit can be rotated to correctly position the logo for any mounting
arrangement, such as when the unit is mounted on a vertical wall, the logo should oriented with the Cisco
Systems positioned on top. The logo should always be oriented to ease reading.
To rotate the Cisco logo, peform these steps:
Place the end of an opened paper clip into one of the holes on the logo assembly (see
Step 1
Figure 2-11 Cisco Logo Holes
1
3
Using the paper clip as a handle, rotate the logo until you reach the desired orientation.
Step 2
Step 3
Remove the paper clip.
OL-6226-01
C I S C O C O N F I D E N T I A L -
2-16.
Cisco logo
Logo assembly holes
"Attaching the Access Point to the Mounting Plate"
2-17.
2
Status LED
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Mounting Above a Suspended Ceiling
D r a f t 2
"Connecting the Ethernet and
Figure
2-11).
2-15