Mounting Above A Suspended Ceiling - Cisco Aironet 1130AG Series Hardware Installation Manual

Chapter 2 Installing the Access Point

Mounting Above a Suspended Ceiling

The access point mounting bracket is designed to be integrated into the T-bar grid above the tiles of a
suspended ceiling. The access point uses a T-bar box hanger (not supplied) such as the Erico Caddy 512
or B-Line BA12 and should be oriented just above the top surface of a standard 5/8-in. (1.59 cm) ceiling
tile. You may need to modify a thicker tile to allow room for the access point.
Caution Only the fiber-optic power injector (AIR-PWRINJ-FIB) has been tested to UL 2043 for operation in a
building's environmental air space, the AIR-PWRINJ3 power injector and the power module are not tested
to UL 2043 and should not be placed in a building's environmental air space, such as above suspended
ceilings.
Cisco does not sell Ethernet cable rated for use in a building environmental air space, such as above
Caution
suspended ceilings. You must obtain special Ethernet cable with the appropriate rating.
Follow these steps to mount the access point above a suspended ceiling. Refer
proceeding.
Figure 2-9
1
2
3
Step 1 Insert the bracket mounting clip's tab into the rectangular hole on the access point mounting bracket.
OL-6226-01
C I S C O C O N F I D E N T I A L -
T-Bar Grid Mounting Bracket Parts
6
Suspended ceiling T-rail
T-bar box hanger
Bracket mounting clip
D r a f t 2
1 3 4
5
4 Access point mounting bracket
5 Access point
6
T-rail clip
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Mounting Above a Suspended Ceiling
Figure 2-9 before
2 6 1
2-13