Srs Component Replacement/Inspection After Deployment - Honda 2011 Odyssey Body Repair Manual

General Information

SRS Component Replacement/Inspection After Deployment

NOTE:
Before doing any SRS repairs, check for DTCs with the
●
HDS; refer to the appropriate Odyssey Service
Manual, for the less obvious deployed components
(front seat belt tensioners, driver's seat belt outer lap
tensioner, front impact sensors, side impact sensors,
rear safing sensor, etc).
Do not repair damaged SRS'wiring. Replace the
●
affected wiring harness(es).
Do not replace the ODS unit unless it is physically
●
damaged or a specific fault was found during DTC
troubleshooting. Because it could complicate
troubleshooting other DTCs.
After a vehicle collision, do the ODS unit operation
●
check; refer to the appropriate Odyssey Service
Manual.
After a vehicle collision, inspect the front seat active
●
head restraints; refer to the appropriate Odyssey
Service Manual.
After a collision where the front seat belt tensioners
deployed, replace these items:
SRS unit
●
Front seat belt(s)
●
Driver's seat belt outer lap tensioner
●
Front impact sensor(s)
●
After a collision where the driver's seat belt outer lap
tensioner deployed, replace there items:
SRS unit
●
Front seat belt(s)
●
Driver's seat belt outer lap tensioner
●
Front impact sensor(s)
●
After a collision where the front airbag(s) deployed,
replace these items:
SRS unit
●
Deployed front airbag(s)
●
Front seat belt(s)
●
Driver's seat belt outer lap tensioner
●
Front impact sensor(s)
●
Dashboard
●
1-4
After a collision where the side airbag has deployed,
replace the items for the side(s) that deployed:
SRS unit
●
Deployed side airbag(s)
●
Side impact sensor(s) (first)
●
Side impact sensor(s) (second)
●
Side impact sensor(s) (third)
●
Rear safing sensor
●
B-pillar lower trim
●
Seat frame and related parts
●
Front seat belt(s)
●
Driver's seat belt outer lap tensioner
●
After a collision where a side curtain airbag has
deployed, replace the items for the side(s) that deployed:
SRS unit
●
Front seat belt(s)
●
Driver's seat belt outer lap tensioner
●
Deployed side curtain airbag(s)
●
Side impact sensor(s) (first)
●
Side impact sensor(s) (second)
●
Side impact sensor(s) (third)
●
Rear safing sensor
●
A-pillar upper trim
●
B-pillar upper trim
●
C-pillar trim
●
D-pillar trim
●
Front grab handle
●
Rear grab handle
●
All related trim clips
●
Sunvisor
●
Headliner
●
After a moderate to severe side or rear collision, inspect
for any damage on the side curtain airbag or other
related components. Replace the components as
needed.
During the repair process, inspect these areas:
Inspect all the SRS wire harnesses. Replace, do not
●
repair, any damaged harnesses.
Inspect the cable reel for heat damage. If there is any
●
damage, replace the cable reel; refer to the
appropriate Odyssey Service Manual.
After the vehicle is completely repaired, turn the ignition
switch to ON (II). If the SRS indicator comes on for about
6 seconds and then goes off, the SRS is OK. If the
indicator does not function properly, use the HDS to
check for the DTCs; refer to the appropriate Odyssey
Service Manual. If you cannot retrieve a code, do the
SRS Symptom Troubleshooting.