Option (Specification Setting Mode) - Canon imageRUNNER ADVANCE C255 Series Service Manual

COPIER (Service mode for copier) > FUNCTION (Operation / inspection mode) > DBG-LOG
LOG-TRIG
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
HIT-STS
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
SYSLOG
DEFAULT
Detail
Use Case
Adj/Set/Operate Method
LOG-DEL
Detail
Use Case
Adj/Set/Operate Method
HIT-STS2

OPTION (Specification setting mode)

■ FNC-SW
COPIER (Service mode for copier) > OPTION (Specification setting mode) > FNC-SW
MODEL-SZ
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
DH-SW
2 Set of debug log storage condition
To set the conditions (timing, types, etc.) to automatically store the debug logs (stored as an archive
file).
By reading the operation setting file of the setting value from the Main Controller, the conditions
written in the file are set.
When setting a new condition is necessary, read the operation setting file provided by R&D from
the USB memory.
- When changing the conditions of debug log to automatically store
- When setting a new condition
Enter the setting value, and then press OK key.
0 to 99999
COPIER> FUNCTION> DBG-LOG> LOG2USB, LOG2SRVR
2 Display of debug log state
To display whether archive file of the debug log which is matched with the conditions set in LOG-
TRIG exists or not.
When checking the debug log automatically saved
Select the item, and then press OK key.
At normal state: OK, At failure occurrence: --
COPIER> FUNCTION> DBG-LOG> LOG-TRIG
2 For R&D
2 Reset of debug log setting
To clear all debug log settings and return to the state before debug log collection operation.
- When returning the device in which analyzing the cause of a problem was completed
- When resetting the debug log settings
Select the item, and then press OK key.
2 Clearing of debug logs
To delete the debug log file.
The debug log setting is not reset.
When clearing the debug log
Select the item, and then press OK key.
2 For R&D
1 Fixed magnifictn & DADF orgnl dtct size
To set the fixed magnification ratio display and the original detection size with DADF.
It is set automatically at the time of installation of the Reader according to the location.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 3
0: AB configuration (6R5E) for Japan, 1: Inch configuration (5R4E) for North/Middle/South
America, 2: A configuration (3R3E) for Europe, 3: AB/Inch configuration (6R5E) for Asia, Oceania,
South America
It differs according to the location.
2 For R&D
710
8. Service Mode