Adjust (Adjustment Mode) - Canon imageRUNNER ADVANCE C255 Series Service Manual

Address bit
P023
1 -
0 -
P024 15 -
14 -
13 Cassette 3 Pullout Sensor
12 Cassette 3 Paper Surface Sensor
11 Cassette 3 Paper Sensor
10 Cassette 4 Paper Sensor
9 Cassette 4 Paper Surface Sensor
8 Cassette 4 Pullout Sensor
7 -
6 -
5 -
4 -
3 -
2 -
1 -
0 -

ADJUST (Adjustment mode)

■ ADJ-XY
COPIER (Service mode for copier) > ADJUST (Adjustment mode) > ADJ-XY
ADJ-X 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Name
Adj read start pstn: Copyboard,vert scan
To adjust the image reading start position (image leading edge position) in the vertical scanning
direction at copyboard reading.
As the value is incremented by 1, the image position is moved to the trailing edge side by 0.1 mm.
Decrease the value when the non-image width is larger than the standard value.
Increase the value when out of original area is copied.
When replacing the Main Controller PCB/clearing the Reader-related RAM data/replacing the
SATA Flash PCB, enter the value of the service label on the reader.
When replacing the Main Controller PCB/clearing the Reader-related RAM data/replacing the
SATA Flash PCB
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-30 to 30
mm
0
0.1
Circuit code
PS102
PS108
PS105
PS106
PS109
PS103
582
8. Service Mode
Remarks
- -
- -
- -
- -
H: Paper
L: ON
L: Paper
L: Paper
L: ON
H: Paper
- -
- -
- -
- -
- -
- -
- -
- -