8. Remove the Pressure Roller Unit [1].
NOTE:
Actions at installation
• Apply grease (MOLYKOTE HP-300 GREASE: QY9-0035) to the 2 locations [1] where the bearings of a new Pressure Roller
is installed.
• Be sure to affix felt [1] to the 2 [A] parts of the Fixing Assembly.
(If felt is already affixed, remove the old felt, clean the portion with lint-free paper moistened with alcohol, and affix new felt.)
Removing the Fixing Drive Unit
■ Preparation
1.
"Removing the Rear Cover 1" on page 140
2.
"Removing the Main Controller Unit" on page 189
3.
"Removing the Low-voltage Power Supply Unit" on page 201
4.
"Removing the Fixing Assembly" on page 254
[1]
[1]
[A]
4. Parts Replacement and Cleaning
[1]
[1]
259
[1]
[A]