38400 Baud Connections
Wire Color/Description
BLUE - NMEA GPS Input (+)
GREEN - NMEA GPS Input (−)
GRAY - NMEA DSC Output (+)
BROWN - NMEA DSC Output (−)
YELLOW - AIS Data Output (+)
WHITE - AIS Data Output (−)
*1: The GPS chart plotter ComPort must be setup to 38400 baud (HS) to receive DSC and AIS
sentences from the GX6500E/GX6000E (Gray and Brown wires).
*2: The GX6500E/GX6000E always outputs NMEA 0183-HS VDM sentence at 38400.
Note: Some GPS chart plotters have a single wire for NMEA signal ground. In such a case connect
the NMEA input (−) to the GPS chart plotter's single NMEA signal ground wire, and leave the NMEA
output (−) open. In case the assignment of power supply and ground of a GPS chart plotter to be
used is different from that of the radio, connect the signal ground wire of the GPS chart plotter to
the ground terminal (GND) on the rear panel of the radio.
Page 22
GPS Antenna
Radio Wires
Blue: NMEA IN ( )
Green: NMEA IN ( )
Gray: NMEA OUT ( )
Brown: NMEA OUT ( )
Yellow: NMEA-HS OUT ( )
White: NMEA-HS OUT ( )
No connection
No connection
NMEA (+) input of GPS*
NMEA (−) input of GPS*
No connection*
No connection*
Plotter Connection
No Connection
No Connection
NMEA IN ( )
NMEA IN ( )
No Connection
No Connection
Connection Examples
1
1
2
2
GX6500E/GX6000E
GPS Chart Plotter