Oral-B GENIUS 9000 Manual page 22

Reset to factory
settings.
TOOTHBRUSH
Handle is not
operating
(during first
use).
Handle does
not operate
with existing
SmartGuide in
household.
1. Short stutter-
ing sounds/
flashing light
every 30 sec-
onds or after
2 minutes.
2. Handle does
not operate
any timer.
Handle does
not charge and
blinks.
Original functionality wanted.
1. Handle has not been activated.
2. Battery has a very low charge
level; no lights illuminate.
1. Synchronizing with existing
SmartGuide failed.
2. Radio transmission is deacti-
vated; radio transmission display
(7) is turned off.
3. SmartGuide is not compatible
with handle.
4. Two handles are already
assigned to SmartGuide.
5. Function is deactivated via App
feature.
1. «Professional timer» or
«2-Minute timer» activated.
2. Timer has been modified/
deactivated via App.
Ambient temperature for charging
is out of valid range (
≥
60 °C).
Press and hold on/off button (3)
for 10 seconds until all indicator
lights double blink simultaneously.
1. Briefly place handle on
2. Charge at least for 30 min.
1. Synchronize (existing) handle(s)
2. Activate radio transmission by
3. Handle cannot be used with
4. You can synchronize a total of
5. During use of special App fea-
1. Set your timer to 2-Minute timer
2. Use App to change timer set-
Recommended ambient tempera-
≤
0 °C and ture for charging is 5 °C to 35 °C.
plugged-in charging unit. It may
take up to 10 min., until charge
level display (8) flashes.
(again) via SmartGuide settings
in SmartGuide's battery com-
partment: Press «h/min» for
3 seconds. Turn on handle that
you want to synchronize. Then
turn on second handle you want
to synchronize. Press «h/min» or
«set» to exit synchronization
mode.
simultaneously pressing on/off
(3) and mode button (4) for
2 seconds until radio transmis-
sion display (7) turns on.
excisting SmartGuide.
2 handles only. Change handles
via SmartGuide settings (see 1.)
tures, transmission to Smart-
Guide may be deactivated.
You can also (de)activate any
SmartGuide communication via
App.
(stuttering sounds/flashing light
after 2min); or set your timer to
Professional timer (stuttering
sounds/flashing light every
30 seconds). Follow steps under
«Timer setup».
tings or perform factory reset
(see App Trouble Shootings).
23