Telnet Command: Ha Show - Draytek VIGOR2925 SERIES User Manual

-h <Subnet> [<Virtual
IP>]
-d <Subnet>
E x a m p l e
E x a m p l e
> ha set -h LAN1 192.168.1.5
% Enable Virtual IP on LAN1
% Set Virtual IP 192.168.1.5 OK!!
>
T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command can be used to show the settings information about config sync and general
setup.
S y n t a x
S y n t a x
ha show –c
ha show –g
S y n t a x D e
S y n t a x D e
Parameter
-c
-g
E x a m p l e
E x a m p l e
> ha show -g
% High Availability
% Redundancy Method
% Group ID
% Priority ID
% Preempt Mode
% Update DDNS
% Management Interface : LAN1
% Authentication Key
% Syslog
%
% [ Index | Enable | Virtual IP ]
% LAN1
% LAN2
% LAN3
% LAN4
Enable and set virtual IP to the subnet.
Subnet: LAN1 to LAN5, DMZ.
Virtual IP: The type format shall be "xxx.xxx.xxx.xxx". (e.g,
192.168.1.0)
For example, to enable a virtual IP to the sunet, simply type:
ha set –h LAN1 192.168.1.5
Disable a virtual IP to the subnet.
Subnet: LAN1 to LAN5, DMZ.
For example, to disable a virtual IP to the subnet, just type:
ha set –h LAN1
: h a s h o w
: h a s h o w
s c r i p t i o n
s c r i p t i o n
Description
Show the settings of config sync.
Show the settings of general setup.
: Disable
: Active-Standby
: 1
: 10
: Enable
: Disable
: draytek
: OFF
- 0.0.0.0
- 0.0.0.0
- 0.0.0.0
- 0.0.0.0
761
Vigor2925 Series User's Guide