Telnet Command: Ip6 Dhcp Server - Draytek VIGOR2925 SERIES User Manual

DHCPv6 client enabled
request IA_NA whose IAID equals to 2008
> system reboot
T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command allows you to configure DHCPv6 server.
ip6 dhcp server [-<command> <parameter>| ... ]
S y n t a x D e
S y n t a x D e
Parameter
server
[<command>
<parameter>|...]
-a
-i<pool_min_addr>
-x<pool_max_addr>
-d<addr>
-D<addr>
-c<parameter>
-e<parameter>
E x a m p l e
E x a m p l e
> ip6 dhcp server -d FF02::1
> ip6 dhcp server -i ff02::1
> ip6 dhcp server -x ff02::3
> ip6 dhcp server -a
% Interface LAN has following DHCPv6 server settings:
% DHCPv6 server disabled
% maximum address of the pool: FF02::3
% minimum address of the pool: FF02::1
% 1st DNS IPv6 Addr: FF02::1
: i p 6 d h c p s e r v e
: i p 6 d h c p s e r v e
s c r i p t i o n
s c r i p t i o n
Description
It means the dhcp server settings.
The available commands with parameters are listed below.
[...] means that you can type in several commands in one
line.
It means to show current DHCPv6 status.
It means to set the start IPv6 address of the address pool.
It means to set the end IPv6 address of the address pool.
It means to set the first DNS IPv6 address.
It means to set the second DNS IPv6 address.
It means to send rapid commit to server.
1: Enable
0: Disable
It means to enable or disable the DHCPv6 server.
1: Enable
0: Disable
r
r
617
Vigor2925 Series User's Guide