Draytek VIGOR2925 SERIES User Manual page 540

Hide thumbs Also See for VIGOR2925 SERIES:

Table of Contents

Periodic Inform Settings

STUN Settings

Apply Settings to APs

Vigor2925 Series User's Guide

Test With Inform – Click it to send a message based on

the event code selection to test if such CPE is able to

communicate with VigorACS SI server.

Event Code – Use the drop down menu to specify an event

to perform the test.

Last Inform Response Time – Display the time that

VigorACS server made a response while receiving Inform

message from CPE last time.

Such information is useful for Auto Configuration Server.

Enable/Disable – Allow/Deny the CPE Client to connect

with Auto Configuration Server.

Port – Sometimes, port conflict might be occurred. To

solve such problem, you might change port number for

Username and Password – Type the username and

password that VigorACS can use to access into such CPE.

The default setting is Enable. Please set interval time or

schedule time for the router to send notification to CPE. Or

click Disable to close the mechanism of notification.

The default is Disable. If you click Enable, please type the

relational settings listed below:

Server IP – Type the IP address of the STUN server.

Server Port – Type the port number of the STUN server.

Minimum Keep Alive Period – If STUN is enabled, the

CPE must send binding request to the server for the purpose

of maintaining the binding in the Gateway. Please type a

number as the minimum period. The default setting is "60

Maximum Keep Alive Period – If STUN is enabled, the

CPE must send binding request to the server for the purpose

of maintaining the binding in the Gateway. Please type a

number as the maximum period. A value of "-1" indicates

that no maximum period is specified.

This feature is able to apply TR-069 settings (including

STUN and ACS server settings) to all of APs managed by

Vigor2925 at the same time.