Draytek vigor3900 User Manual page 307

Enable
Protocol
Source IP Address
Source Mask
Destination IP
Address
Destination Mask
Destination Port
Start
Destination Port
End
Load Balance Pool
Apply
Cancel
4. Enter all the settings and click Apply.
5. A new profile has been created.
Vigor3900 Series User's Guide
Check this box to enable such profile.
Choose the protocol for such profile.
Type the source IP address specified for this profile.
Type the subnet mask address specified for the source IP.
Type the destination IP address specified for this entry.
Type the subnet mask address specified for the destination
IP.
Type the start point.
Type the end point.
Use the drop down list to choose one profile configured in
load balance pool. Then, such rule will be applied by the
pool.
Click it to save the configuration.
Click it to exit the page without saving the configuration.
299