Gear Selector - Honda 2010 CBX 250 Workshop Manual

CBX250
Install the washer
Apply motor oil to the thread and to the surface
of settlement of the nut primary gear command.
Then, install it on the crankshaft. Using the spe-
cial tool fasten the nut gear primary command to
the specified torque. Tool:
Support of the body of the clutch
TORQUE: 108 N.m (10,8 kg.m)
Install the following components:
All the components of clutch (page 9-8)
Lid right side of the casing of the engine (page 9-12)

GEAR SELECTOR

NOTE
Refer to Section 11 to obtain information with regard to
services in the spindle of gears.
DISMANTLING
Remove the cover right side of the casing
of the engine (page 9-3).
Remove the bolt and the plate of leva of
changing gears.
Remove the bolt, the arm limiter drum
gearbox, the washer and the spring of
return.
Remove the ear of guide of the drum
selector.
INSPECTION
Also Inspect the plate of cam change of gears and the arm
limiter with regard to wear or damage. Check the spring of
return of the arm limiter with regard to fatigue or damage.
INSTALLATION
Install the spring of return, the washer (between the
arm limiter and spring), the arm limiter and the bolt.
Tighten the bolt arm limiter to value specified.
TORQUE: 12 N.m (1,2 kg.m)
07724-0050002
CLUTCH/GEAR SELECTOR
NUT PRIMARY GEAR COMMAND
SUPPORT OF THE BODY OF THE CLUTCH
ARM LIMITER OF
CHANGING gears
WASHER
BOLT
RETURN SPRING
RETURN SPRING
ARM LIMITER OF CHANGING gears
WASHER
BOLT
PLATE OF CAM gears
WASHER
BOLT