Fuel Tank Dismantling/Installation; Front Fenders Dismantling/Installation - Honda 2010 CBX 250 Workshop Manual

Chassis/FAIRING/EXHAUST SYSTEM
FUEL TANK
d
• The petrol (gasoline) is extremely flammable and
explosive under certain conditions. Keep out of the
reach of children. •Immediately Clean petrol (gasoline)
in case of bloodshed. •Work on a local well ventilated.
The presence of cigarettes, flames or sparks in the
local labour or where stocks petrol (gasoline) can
cause a fire or explosion.
DISMANTLING/Installation
Remove the saddle (page 2-2). Remove the plates baffles side
(p. 2-3). Closing the valve of fuel. Disconnect the tube of fuel
valve of fuel.
NOTE
During the dismantling, be careful not to damage the
connector 2P and sensor wiring of fuel level.
Remove the bolt fixing of tank and the collar. Then, apart
from the projections of the lids and the side and gums of fuel
tank. Disconnect the connector 2P sensor level of fuel.
Besides the fuel tank and gum fixation, pulling the tank
backwards. The installation is performed in reverse order
dismantling.
NOTE
After the installation turn the valve of fuel for the pos-
ition ON (open) and make sure that there is no fuel leaks.
FRONT FENDERS
DISMANTLING/Installation
Remove the screw and disconnect the cable from the gear
box of the speedometer, located in the fork of the
suspension. Remove the fixing bolts the fenders, the front
fenders, support, and the pin of the hose front brake. The
installation is performed in reverse order dismantling.
NOTE
Tighten fixing bolts the front fenders and the pin of the
hose of the brake.
2-4
FUEL TANK
PIN OF THE HOSE OF
THE brake
FRONT FENDERS
SUPPORT
OF THE SPEEDOMETER
CBX250
BOLT
COLLAR
CONNECTOR 2P
SENSOR FUEL LEVEL
BOLT
CABLE
Gear Box
SCREW