Table Of Instruments; When The Power Switch Is Turned Off Position), The Indicator Of Speed Or Tachometer Not Aligns With The 0 Of The Bar Indicator; Investigation Of Faults - Honda 2010 CBX 250 Workshop Manual

LIGHTS/INDICATORS/SWITCHES
SPECIFICATIONS
Light bulbs Headlight
Rear/light of brake
Indicator front direction
Indicators rear
Light of the instruments
Indicator of indicator
Indicator of the headlight high
Neutral Indicator
Sidestand indicator
Fuses Main fuse
Auxillary fuse
T
ORQUE VALUES
Bolt pivot of side stand
Against the pivot bracket
Bolt breaker of bracket
Nut terminal breaker of deadlock
Body breaker deadlock

INVESTIGATION OF FAULTS

Table of instruments

•Prior to inspect the picture of instruments, make sure that the battery, the fuse main (20), the auxillary fuse (15),
the fuse in the clock / kilometer (10) and the connector 16 of the speedometer are in good condition and firmly
connected.
•Turn the power switch toward the position ON and inspect the following: Verify if indicators of the speedometer
and tachometer returning to the point of origin. Check to see if the desk digital lights.
When the power switch is turned OFF position), the indicator of speed or tachometer not aligns with the 0 of the bar
indicator.
Turn the power switch for the position on.
The indicator of speed or tachometer
should go back and align with the 0 of the
bar indicator.
Abnormal
Disconnect the cable positive (+) battery.
Wait a few seconds plug back and check the
functioning of the table of instruments.
19-2
Item
High
Low
Abnormal
Specifications
10 A x 3, 15 A x 1
10 N.m (1,0 kg.m)
39 N.m (3,9 kg.m)
10 N.m (1,0 kg.m)
2 N.m (0,2 kg.m)
12 N.m (1,2 kg.m)
• Table of instruments defective.
CBX250
12 V – 35 W
12 V – 35 W
12 V – 5/21 W
12 V – 15 W x 2
12 V – 15 W x 2
LED
LED
LED
LED
LED
20 A