5.3
Boot completed
Introduction
After an error-free boot of the NCU, it displays the following:
● Number "6" and a flashing point
● LED RUN illuminates GREEN continuously
To resume the startup on the user interface of the HMI, the following operator input
sequence steps are necessary:
Operator input sequence steps for entry into startup
1. Press <Menu Select>
2. Press "Commissioning".
Figure 5-2
3. Press "Password...".
4. Press "Set password".
5. Enter the manufacturer's password "SUNRISE".
6. Press "OK".
Run-up has been completed.
In the following step, commissioning of the PLC is done with the SIMATIC Manager.
See also
Triggering a reset (warm restart) for NCK and drive system (Page 57)
IBN CNC: NCK, PLC, drive
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
, or the <F10> key on the PG/PC.
"Commissioning" menu
Power on and boot up
5.3 Boot completed
35