Siemens SINUMERIK 804D sl Commissioning Manual page 159

Machine data
Table 10-26 Referencing: Machine data
Number Name of Identifier
General ($MN_ ... )
11300 JOG_INC_MODE_LEVELTRIGGRD
Channelspecific ($MC_ ... )
20700 REFP_NC_START_LOCK
axisspecific ($MA_ ... )
30200 NUM_ENCS
30240 ENC_TYP
30242 ENC_IS_INDEPENDENT
31122 BERO_DELAY_TIME_PLUS
31123 BERO_DELAY_TIME_MINUS
34000 REFP_CAM_IS_ACTIVE
34010 REFP_CAM_DIR_IS_MINUS
34020 REFP_VELO_SEARCH_CAM
34030 REFP_MAX_CAM_DIST
34040 REFP_VELO_SEARCH_MARKER[n]
34050 REFP_SEARCH_MARKER_REVERSE[n]
34060 REFP_MAX_MARKER_DIST[n]
34070 REFP_VELO_POS
34080 REFP_MOVE_DIST[n]
34090 REFP_MOVE_DIST_CORR[n]
34092 REFP_CAM_SHIFT
34100 REFP_SET_POS[n]
34102 REFP_SYNC_ENCS
34110 REFP_CYCLE_NR
34120 REFP_BERO_LOW_ACTIVE
34200 ENC_REFP_MODE[n]
34210 ENC_REFP_STATE[n]
34220 ENC_ABS_TURNS_MODULO
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
Name
INC/REF in jog/continuous mode
NC start disable without reference point
Number of encoders
Actual value encoder type
Encoder is independent
BERO delay time in plus direction
BERO delay time in minus direction
Axis with reference cam
Reference point approach in minus direction
Reference point approach velocity
Maximum distance to reference cam
Reference point creep speed [encoder
number]
Change of direction on reference cam
[encoder number]
Maximum distance to reference mark;
Maximum distance to 2 reference marks with
distance-coded scales [encoder number]
Reference point positioning velocity
Reference point distance/target point with
distance-coded system [encoder number]
Reference point/absolute offset, distance-
coded [encoder number]
Electronic reference cam shift for incremental
measurement systems with equidistant zero
marks.
Reference point value [reference point
number]
Actual value adjustment to the referencing
measurement system
Axis sequence for channel-specific referencing
Polarity change of BERO
Referencing mode [encoder number]
Status of absolute value encoder [encoder
number]
Absolute value encoder range for rotary
encoders
NCK start-up
10.5 Parameterize axis data
Referenc
e
H1
G2
G2
S1
S1
R2
159