Special Preset Commands, Pelco Protocol; Setting The Addresses Of The Two Cameras Of The Mic612 - Bosch MIC612 Installation Manual

MIC612 Thermal Camera
Keyboard Command User Action
0-Pattern
1-Pattern
2-Pattern
3-Pattern
4-Pattern
1 – Aux On / Aux Off Press
2 – Aux On / Aux Off Press
91 – Aux On
92 – Aux On
5.3.5

Special Preset Commands, Pelco Protocol

Some Pelco mode preset commands have a special meaning and override the normal Pelco
preset function as follows:
Preset Command
33-PRESET
34-PRESET
81-PRESET
82-PRESET
92-PRESET
93-PRESET
94-PRESET
95-PRESET
96-PRESET
97-PRESET
99-PRESET
NOTICE!
Some Pelco controllers do not support all of the preset command numbers. Consult the
documentation of the specific Pelco controller for supported preset commands.
5.4

Setting the Addresses of the Two Cameras of the MIC612

After the camera is on, you must set the camera address. The optical camera and the thermal
camera of the MIC612 have different addresses. The address of the optical camera is set via
the OSD and FastAddress. The address of the thermal camera is set via the OSD and a unique
address. From the factory, the default address of the optical camera is "0" and the default
address of the thermal camera is the address of the optical camera + 1.
Bosch Security Systems, Inc.
Description
Press Initiates recording continuous playback based upon
current Recording setting (A or B) in the Setup Menu.
Press and hold Initiates recording based upon current Recording
setting (A or B) in the Setup Menu. Press ACK to end
recording.
Press Initiate Recording A continuous playback.
Press and hold Initiate Recording A. Press ACK to end recording.
Press Initiate Recording B continuous playback.
Press and hold Initiate Recording B. Press ACK to end recording.
Press Initiate the MIC612 standard preset tour (Tour 1).
Press Initiate the MIC612 custom preset tour (Tour 2).
Activates / deactivates alarm output 1.
This command is supported only if an 8-input alarm
card is installed in the PSU powering the camera.
Activates / deactivates alarm output 2.
This command is supported only if an 8-input alarm
card is installed in the PSU powering the camera.
Press Activate Zone Scan (display zone titles).
Press Deactivate Zone Scan (re-move zone titles)
Description
Pans the camera 180° (Flip).
Goes to Zero Pan (original home position).
Initiates Preset Tour 1.
Initiates Preset Tour 2.
Sets the Left pan limit for an AutoScan with Limit Stops enabled.
Sets the Right pan limit for an AutoScan with Limit Stops enabled.
Initiates a Preset Tour.
Enables or disables Limit Stops in the Setup Menu for AutoScan.
Invokes the Pelco main Setup Menu when pressed for 2 seconds.
Stops a scan.
Initiates FastAddress (Pelco Random Scan).
Starts an AutoScan.
Installation Manual
Getting Started | en 31
F.01U.249.416 | 1.1 | 2012.03