Other Menus - Bosch MIC612 Installation Manual

54 en | On-Screen Display (OSD) Menus (Pelco Protocol)
PTZ Setup Menu Choices:
Menu
Exit
Edit Tour 1
Edit Tour 2
Tour 1 Period
Tour 2 Period
Scan Speed
Edit Presets
Limit Stops
Recordings
AutoPivot
7.4

Other Menus

Menu
Edit Password
FastAddress
Software Version
Ack and Reset Alarms
Restore All Settings
Reset All Memory
F.01U.249.416 | 1.1 | 2012.03
Description
Exits the menu.?
Accesses the Add / Remove
Scenes On Standard Tour 1
Menu.
Accesses the Edit Custom
Tour Menu.
Changes the length of
waiting time between
presets.
Changes the length of
waiting time between
presets.
Changes the Autopan and
AutoScan speeds.
Modifies preset scenes.
Toggles the Limit Stops for
AutoScan.
Selects record Pattern 1 or
2, if normal pattern
command does not
respond.
Follows a subject while
beneath the camera,
without inverting the
picture.
Description
Sets or displays the password. See Section 5.5 Setting
Passwords, page 34.
Sets or changes the address.
Displays the camera software version.
Acknowledges and resets alarms. If there is no active
alarm input, the OSD displays the following message:
"
No Active Alarms.
Restores all settings to their original factory default
settings.
Restores all settings to their original factory default
settings and clears all user programmed settings such
as preset scenes and recordings.
Installation Manual
Sub-menu / Description
Exit: Exits the menu.
Scene (1 - 5): Adds or removes
scenes from the Standard Tour.
Exit: Exits the menu.
Scene (1 - 5): Adds or removes
scenes from the Custom Tour.
Sliding scale: – (3 sec. to 10 min.) + 5 sec.
Sliding scale: – (3 sec. to 10 min.) + 5 sec.
Sliding scale: – (1°/sec to 60°/sec) + 30°/sec.
1-99 scenes
ON or OFF
"A" or "B"
ON or OFF
"
MIC612 Thermal Camera
Default
Setting
OFF
"A"
ON
Default
Setting
Not Set
Bosch Security Systems, Inc.