Navigating The On-Screen Display (Osd) Menus; Keyboard Commands, Bosch Protocol; Keyboard Commands, Pelco Protocol - Bosch MIC612 Installation Manual

30 en | Getting Started
5.3.2

Navigating the On-Screen Display (OSD) Menus

The OSD menus provide access to the programmable settings of the camera. The OSD
displays only the submenus that are applicable to a particular MIC configuration. Some menu
items (indicated as (L)) are locked and require a system password to use. Menu items marked
with an asterisk (*) are default factory settings, unless otherwise noted.
NOTICE!
After 4.5 minutes of inactivity, the OSD menu times out and exits without warning. Some
unsaved settings in the current menu can be lost.
To navigate the OSD menus:
1.
2.
3.
Note: To select the Exit Menu item from anywhere in the current menu, use the Zoom
command.
5.3.3

Keyboard Commands, Bosch Protocol

Keyboard control commands are composed of a sequence of three (3) inputs with the
following convention: 1) a Function key + 2) a Command number key(s) + 3) the Enter key.
–
NOTICE!
The convention used for control key commands in this manual is ON, OFF, SET, and SHOT.
Refer to your keyboard manual for the key naming conventions.
–
–
For example, the keyboard command to make the MIC612 pan 360º continuously is:
ON-1-ENTER (Press the ON key, then press the number 1 key, and then press ENTER.)
5.3.4

Keyboard Commands, Pelco Protocol

Pelco control commands are composed of a sequence of two (2) keyboard inputs with the
following convention: 1) a Command Number and 2) a Function key input.
The MIC612 uses the PRESET command key to save and recall presets (pre-positions) 1
through 99.
NOTICE!
To save a preset, enter the desired number and hold the PRESET key for approximately two
(2) seconds. To recall a preset, enter the desired preset number (or command) and
momentarily press and release the PRESET key.
F.01U.249.416 | 1.1 | 2012.03
Use the joystick to highlight a menu item.
Press either the Focus or the Iris key to open a menu item.
Follow the on-screen instructions.
Depending on the type of keyboard, the control function keys are labeled:
ON or AUX ON
OFF or AUX OFF
SET or SET SHOT
SHOT or SHOW SHOT
Command numbers range from 1 to 999. See Section A Keyboard Commands (Bosch
Protocol) By Number for a complete list of keyboard commands for Bosch protocol.
The Enter key can also be labeled with the ∞ symbol.
Installation Manual
MIC612 Thermal Camera
Bosch Security Systems, Inc.