Simple Stack Mode - Toshiba MJ-1104 Service Manual

3.1.3

Simple Stack Mode

In this mode the transported paper is exited to the stationary tray or the movable tray directly, without
any extra operation.
During the exiting process to the movable tray, the shutter is lifted not to bring the paper into the finish-
ing tray side and the movable tray is lifted up and down according to the stack height of paper.
[A] Finisher paper feeding section
Paper transported from the junction box is then caught with the entrance roller driven by the entrance
motor (M1).
When paper is exited to the stationary tray, the gate solenoid (SOL4) is turned ON to move down the
gate flapper. When exited to the movable tray, the gate solenoid (SOL4) is turned OFF to transport the
paper to the buffer tray.
The paper transport is detected by the entrance sensor (S1).
Gate flap
Entrance roller
Entrance sens
Gate solenoid
Entrance motor
Fig. 3-5
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DESCRIPTION OF OPERATIONS
3 - 4