Table of Contents
Advertisement
(4)
Release the harness out of 1 clamp, and
then disconnect each connector of CN6 and
CN8 on the IF board.
(5)
Remove 2 screws of the IF board bracket.
Note:
When installing, screw the ground terminal
together with the bracket.
(6)
Remove 2 screws, and then take off the front
bracket.
(7)
Remove 2 screws, and then take off the rear
bracket.
(8)
Remove 2 screws, and then take off the junc-
tion box upper transport guide.
(9)
Open the stationary tray.
(10) Remove the spring, and then loosen 2
screws to free the belt tension.
(11) Take off the belt.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
clamp
ground terminal
Fig. 4-245
Front bracket
Junction box upper
transport guide
Fig. 4-246
Spring
Belt
Fig. 4-247
4 - 87
IF board
Rear bracket
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4
Hide quick links:
Advertisement
Table of Contents
