Sensors / Switches (Finisher Section) - Toshiba MJ-1104 Service Manual

4.9

Sensors / Switches (Finisher section)

[A] Entrance sensor (S1)
(1) Take off the stationary tray.
 P.4-1 "[A] Stationary tray"
(2) Remove 1 screw, and then disconnect the
connector to take off the sensor bracket.
(3) Release the latch, and then take off the
entrance sensor.
[B] Transport sensor (S2)
(1) Take off the stationary tray.
 P.4-1 "[A] Stationary tray"
(2) Close the buffer unit-1.
(3) Release the latch while lifting up the actua-
tor, and then disconnect the connector to
take off the transport sensor.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-255
Entrance sensor
Fig. 4-256
Sensor bracket
Fig. 4-257
4 - 91
Sensor bracket
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4